Homend MEATBOX Benutzerhandbuch Seite 22

H O W TO U S E YO U R
M E AT M I N C E R ?
ASSEMBLING
Press the fasten buttonhold the head and insert it into the inlet(when inserting please pay
attention the head must be slanted as per arrow indicated on the top, see fig.1),
then move the head anticlockwise so that the head being fastened tightly .(fig.2) Place the
snake into the head, long end first, and turn to feed the screw slightly until it is
set into the motor housing (fig.3). Place the cutting blade onto the snake shaft
with the blade facing the front as illustrated (fig.4).If it is not fitted properly, meat will
not be grinded. Place the desired cutting plate next to the cutting blade, fitting protrusions
in the slot (fig.5). Support or press the center of the cutting plate with one finger then screw
the fixing ring tight with another hand (fig.6). Do not over tighten.
Place the hopper plate on the head and fix it into position. Locate the unit on a firm place.
The air passage at the bottom and the side of the motor housing should be kept free and
not blocked.
Snail