To Clean The Product; Discard; Technical Data - Meec Tools 012598 Bedienungsanleitung

Caution! Stop the product and remove the battery
before you do maintenance.
6.1

To clean the product

Caution! To prevent damage to the surface of
the product, do not use harsh detergents or abrasive
cleaners.
Caution! Do not let water get inside the product or
on the battery.
● Disconnect and remove the dirt inside the dust bag if
necessary.
● Clean the product externally with a damp cloth if
necessary.
● Use compressed air or a brush to clean hard to get to
areas.
7

Discard

● Make sure that you follow local regulations when you
discard the product. Do not burn the product.
8

Technical data

Specification
Rated voltage
Max. speed (no load)
Planning width
Planning depth
Weight
Noise levels
Sound pressure level, L
pA
Sound power level, L
WA
Maximum vibrations level
1
1 The declared values for vibration and noise, which
have been measured according to a standardized
test method, can be used to compare different tools
with each other and for a preliminary assessment
of exposure. The measurement values have been
determined in accordance with EN 62841-2-
14:2015.
Value
18 V DC
10000/ min
60 mm
0–1.25 mm
2.2 kg
77 dB(A), K=3 dB
88 db(A), K=3dB
Does not exceed 2 m/s
2
Warning! Always wear hearing protection!
Warning! The actual vibration and noise level
when using tools may differ from the specified maximum
value, depending on how the tool is used and the mate-
rial. It is therefore necessary to determine which safety
precautions are required to protect the user, based on
an estimate of exposure in actual operating conditions
(taking into account all stages of the work cycle, e.g. the
time when the tool is switched off and when it is idling, in
addition to the start-up time).
EN
SV
NO
PL
DE
FI
FR
NL
11