Homend JETSTEAM Benutzerhandbuch Seite 27

IMPORTANT: : Make sure that dirty water is
drained after each automatic cleaning cycle
to avoid overflow.
UYARI: The dirty water in the dirty water
tank will be hot after the automatic cleaning
process. Therefore, be careful when pouring.
Once the system makes sure that mineral
deposits are removed, the indicator will turn
off.
Cord winding
When the product is not in use, the steam
supply hose and power cord can be wound
along the cord winding slot for storage. Apply
the procedures set forth in the item 4 of the
"CLEANING AND MAINTENANCE" section.
Automatic power off
The appliance will turn off automatically after
10 minutes if no steam is emitted from the
base. If the appliance does not emit steam for
a long time during the first use, it will enter in
the energy saving mode. If you need to exit
the energy saving mode, simply press the
steam trigger once. Meanwhile, the selected
the steam rate indicator will flash and the
appliance will release the steam after the
indicator flashes for 30 seconds.
USING YOUR STEAM STATION
The appliance has two ironing modes.
You can use dry ironing or steam ironing. See
below for details:
Dry ironing
1. Place the iron on the heat insulation stand
of the unit base.
2. Connect the plug to the wall socket and
press the power button,
2 5
indicator will light on.
3. Set the temperature dial to the desired
setting depending on the fabric of the
garment. The temperature indicator will then
light on and the iron will start to heat up.
When selecting the temperature, refer to the
"IRONING TIPS" and "ADDITIONAL TABLE"
sections below.
4. When the temperature indicator turns
off, your iron has reached the selected
temperature. You can now start ironing.
WARNING: Never touch the hot base before
it cools down.
Steam ironing
1. Grasp the handle to remove the water tank,
then fill it with water through the filler hole.
It is recommended to use purified water
with less calcium particles. Then insert the
water tank into place properly. The maximum
capacity of the water tank is 1.8 liters. The
water level must not exceed the "MAX" mark.
2. Place the iron on the heat insulation stand
of the unit base.
3. Connect the plug to the wall socket, press
the power button and the default low steam
rate indicator will flash. Three modes are
available, namely low, medium and high
steam rate,
you can select the desired steam rate for each
garment according to your need. Make sure
there is enough water in the tank.
J E T S T E A M