Important Warnings - Homend Jetsteam Benutzerhandbuch

IT IS UP TO YOU TO USE
YOUR STEAM IRON SAFELY.

IMPORTANT WARNINGS!

BEFORE FIRST USE
1. Remove the label or protective foil from the
base
2. Heat the iron to maximum temperature and
then iron on a damp cloth for a few minutes to
remove any residue from the base according
to the "Steam Ironing" section.
NOTE: It is normal for the unit to emit a
strange odor when first used. This will
disappear after a short time.
NOTE: When you use the iron for the first
time, some particles may come out from
the base. This is normal, the particles are
harmless and will stop coming out of the iron
after a short time.
NOTE: When you turn on the appliance, the
steam generator may make a pumping sound.
This is normal, this sound indicates that water
is being pumped into the steam generator.
NOTE: During the heating process of the
base, very little steam will automatically come
out of the base and this will continue for
about 3 seconds. This is normal.
U S E R ' S M A N U A L
Water tank
The water tank of the iron with steam boiler
can be removed. Water can be added in the
case of water shortage while the iron is in use.
You can also fill the water tank with water
through the filler hole. The water tank has a
maximum
capacity is 1.8 liters. Make sure that the water
does not exceed the "MAX" mark.
Power button
Connect the plug of the appliance to the
socket and press the power button. The
power indicator will light on, the low steam
rate will be considered as default and the
indicator will flash. Press the power button for
about 2 seconds, then the appliance will be
disconnected from the power supply.
Steam rate control button
The iron has 3 steam rates. With the steam
rate control button, the steam rate can be
selected as low, medium or high. When any of
them is selected, the indicator will flash and
will light steadily after the preheating process
is completed.
Temperature dial
Turn the dial to set the ironing temperature
according to the garment to be ironed.
2 2 0 3