Schedule For User's Program - Lk Smartcomfort Rtw Bedienungsanleitung

ENG | Instruction Manual

SCHEDULE FOR USER'S PROGRAM

: :
: :
: :
: :
: :
: :
: :
: :
: :
6
March
15
1 2 3 4 5 6 7
° C
° F
1 2 3 4 5 6 7
° C
° F
1 2 3 4 5 6 7
° C
° F
1 2 3 4 5 6 7
° C
° F
1 2 3 4 5 6 7
° C
° F
1 2 3 4 5 6 7
° C
° F
1 2 3 4 5 6 7
° C
° F
1 2 3 4 5 6 7
° C
° F
1 2 3 4 5 6 7
° C
° F
www.lkarmatur.com
NO PARAMETERS AND FUNCTIONS
10
bEd: (+) or (-) to set the desired temperature for
programs P1-P9
11
Out: (+) or (-) to set the desired temperature for
programs P1-P9
12
InP: (+) or (-) to set the desired temperature for
remote operation .
Diagnostic function:
closed contact.
20 deG: Temperature units - °C Celsius or °F Fahrenheit
Time format
21 24H (24:00) or 12H (12:00 AM/PM)
22
dSt: Summer time change.
manual change of time. Date is not used.
30 AirC: Calibration of the room temperature display ±5 °C/±8.5
°F. The calibration should be done after 1 day's operating with
the same set temperature. Place a thermo-meter close to the
controller and check the temperature in the room after 1 hour.
When you enter the calibration parameter,
indicate that no calibration has been made. To enter the value
shown on the thermo-meter, use (+) and (-) keys to enter the
real value. Then press
displayed and the value will be stored in the internal memory.
You can cancel the calibration by pressing
31 OutC: Calibration of outdoor temperature sensor ±10 °C/±17
°F. The same calibration procedure described for 30 AirC,
except for the location of the thermometer.
40 LANG Fr/EN: Change of language. Use (+) or (–) keys to
select French or English.
70 rF 70 rF INI: New wireless connection of room temperature unit
INI and antenna. The message
blinks in the display. After a connection has been estab-
71
lished, parameter
the signal strength.
Please, note that parameter
a connection has been established between room unit and
antenna.
71 71 rF -XX.X: Control of the signal strength between room
rF - temperature unit and antenna.
XX.X The function is used to find a suitable location for the room
unit. Green OK-LED indicates good connection. Blinking or
steady red light indicates insufficient signal strength.
The display shows the signal strength.
80 Clr ALL: Resetting to factory settings.
Note: Ensure that you have all necessary information to reset
your installation before using this function.
OK
Press and hold the
pera-tures and parameters in this menu to factory settings.
User programs will also be reset.
Software version
90
99 OK
End: Press the key to exit parameter menu and return to
normal operation.
Reservations for product improvements.
The frame around the symbol shows
YES
automatic change.
no
is displayed to
OK
to confirm. The message
OK
and then
"INI"
is shown and the symbol
will automatically appear for checking
70
cannot be selected when
key for 10 seconds to reset tem-
in
in
during
no
YES
is
.