Technical Data - Lk Smartcomfort Rtw Bedienungsanleitung

ENG | Instruction Manual

TECHNICAL DATA

Operating temperature
Shipping and storage temperature
Setting temperature range
Electrical protection
Batteries
Frequency
MOUNTING OF ROOM TEMPERATURE UNIT WITH LK 120 OR LK
130 SMARTCOMFORT
The room temperature unit should be mounted at a place that has
an average temperature of the house. For optimal performance
radiator thermostats in the room where the temperature unit is
installed should be set in fully open position.
Important! The room temperature unit is neither splash- nor drip-
proof, therefore it must be mounted at a dry place. It must not be
placed where it can be affected by direct sunshine, heat radiation
or draught.
A suitable place is an inner wall in the living room about 1.5 m
above the floor. See mounting picture.
To ensure good air circulation a spacer ring should be placed
between wall and room unit. An opening for the cable is made with
a suitable tool.
1,5 m
20 cm
Interference may occur if the antenna is placed on metal, metal piping, too close to other wireless
devices or power cables. The antenna must not be too close to the room temperature unit during
start-up.
ROOM TEMPERATURE UNIT SMARTCOMFORT RTW
The room temperature unit is equipped with an an-
tenna for wireless communication between actuator
and room temperature unit, batteries and a table top
stand for the room temperature unit.
Connect the antenna to the socket marked
on the actuator.
Note! For long-lasting power, use only non-rechar-
geable Alkaline batteries of high Quality.
Connection for antenna
3
0 °C to 40 °C (32 °F to 104 °F)
-10 °C to 50 °C (14 °F to 122 °F)
5 °C to 37 °C (41 °F to 99 °F)
Class III – IP 20
2 pcs AAA alkaline batteries
868 MHz
www.lkarmatur.com
ROOM TEMPERATURE UNIT
Display
Minus (-)
Left
Escape
Cover for navigation,
escape and edition keys
DISPLAY
1 2
13
12
11
1.
Remote control e.g. via mobile phone.
2. Keyboard's lock function
3. Operating mode
Boost function –Temporary power boost when raising the
4.
temperature setting
5. Program number
6. Service mode
7.
Room temperature ,
8. Temperature
9. °C or °F indicator
10. Program of the current day (the current time bar blinks)
11. Clock
12.
Symbol for reduced temperature,
13. Current day (1=first day of the week)
Communication symbol
14.
room unit and antenna are communicating
Battery indicator , shown when batteries are low.
15.
Change batteries! The programs are saved. Time and
date have to be set.
Terminal block for GSM remote control
Confirmation OK
and LED-indication
3 4
5
6
7
%
10 8
Outdoor temperature
or
, blinks every 1 – 4 minutes when
Plus (+)
Right
Edition
14
15
9