Creality Falcon2 Pro Benutzerhandbuch Seite 41

ERROR:08
Description: The air pressure sensor of the laser module is abnormal.
Solution:
•
Restart the machine to see if the issue is resolved.
•
If the problem persists, contact the after-sales service team for further technical
support.
ERROR:09
Description: The flame sensor of the laser module is abnormal.
Solution:
•
Restart the machine and check if the issue is resolved.
•
If the problem persists, please reach out to after-sales support for technical
assistance.
ERROR:10
Description: The lens sensor of the laser module is abnormal.
Solution:
•
Restart the machine and check if the issue is resolved.
•
If it remains unresolved, contact after-sales support for further technical help.
ERROR:11
Description: The laser module does not have an LD temperature sensor.
Solution:
•
Restart the machine and check if this resolves the issue.
•
If not, contact the after-sales service for technical support.
ERROR:12
Description: Laser module LD sensor short circuit.
Solution:
•
Restart the machine and check if the issue persists.
•
If the problem is unresolved, contact the after-sales service for support.
41