Creality Falcon2 Pro Benutzerhandbuch Seite 4

Instructions
•
Install the Software
Download and install the engraving software (LightBurn).
o
Use the camera's calibration function before engraving to ensure precision.
o
Follow the instructions in the file on the TF card: "Camera Calibration and
o
Alignment".
•
Product Assembly
Follow the assembly steps in the product manual.
o
For further guidance, refer to the video on the TF card under "Assembly
o
Instructions".
•
Adjust the Focus
Place the engraving material on the machine.
o
Use the multi-level fixed focus block to achieve the correct focus.
o
Connect the computer and device to begin the engraving process.
o
•
Make an Engraving Picture
Select the picture or design to engrave.
o
Higher-resolution images will result in clearer engravings.
o
•
Set Parameters
Set the engraving parameters by referring to the file on the TF card:
o
"Parameter Recommendation".
You can also adjust parameters through the engraving software or consult the
o
"Software Operation Tutorial" on the TF card.
•
G-Code for the First Creation
Use the provided G-code file from the TF card to connect the device for the
o
first engraving.
This G-code tests the structural stability of the machine.
o
Use the Frame function to adjust the engraving position before starting.
o
4