pro user RVC7040N Bedienungsanleitung Seite 4

contact your vehicle's
you can just look for a 12V / 24V power
6. The reverse light sockets
connected to them.
positive wire is a coloured
wiring, you can use a 12/24
parts stores to determine
manufacturer's
7. After determining
negative, turn off the ignition
negative cable.
8. Connect the GREEN wire (TRIGGER
monitor wireloom
Replace the reverse
9.
wires with cable ties or electrical
other trigger cables.
10. Re-attach the negative
11. Plug the camera
12. If LEFT/FRIGHT/FRONT
according to above
Connect BROWN wire to e.g. brake
FRONT)
Connect WHITE wire to e.g. left turning
(CAMERA LEFT)
Connect BLUE wire to e.g. right turning
(CAMERA RIGHT)
Monitor Installation
When choosing a location
area that will not
The RVC7040N can be fixed
roof with the dashboard
On dashboard
On Dashboard
A.
1. Before mounting
2. Position the stand to the dashboard
3. Stick the double-side
screws into the
4. Press the stand
5. Snap in the monitor
6. Adjust the mounting
manufacturer
on most vehicles
Usually the negative
wire. If you are uncertain
volt multimeter
which is the positive
instructions for the
which wire is the positive
key, then remove
to reverse light's
light bulb, and then re-install
tape. This trigger
When in reverse
battery cable to the battery.
to CAM-B (CAMERA BACK).
cameras are optioned,
diagram. And plug the camera
trigger
to mount
obstruct your vision
in your vehicle
stand.
the monitor, clean the dashboard
tape foam at the bottom
dashboard.
against the dashboard
to the stand mounting
arms to suit your view angle to the monitor.
for vehicle specific
supply.
have two wires
wire is black and the
about
available at most auto
wire. Follow the
safe use of the multimeter.
and which
the battery's
for back camera) of the
positive(+)
the light socket.
cable has priority
it shows always the back up camera.
please connect
to each connector
(+), and plug camera
signal trigger (+) , and plug camera
signal trigger (+),
the monitor, make
while driving.
on your dashboard
On roof
surface
surface which suits your requirement.
of the stand.
surface to fix the location.
arm.
4
wiring diagrams. Alternatively
the
is the
Secure
compared
the trigger wire
respectively.
to CAM-F (CAMERA
to CAM-L
and plug camera to CAM-R
sure the monitor
or upside down on the
well.
Alternatively screw
all the
to
is in an
in the