Specification Summary; Using Your Headset - Asus Cerberus V2 Schnellstartanleitung

Specification summary

Frequency response: 20Hz-20kHz
Speaker driver: 53mm neodymium magnet speakerdrivers
• Impedance: 32 ohms
Ear cups: 100mm large earcups with ultra breathable material
Connectors: 3.5mm4-pole analog connector (smartdevices)
Extension: 3.5mm3-pole analog headphone & microphone Y-cable
connector
Microphone boom: -40dBsensitivity unidirectional microphone boom
• In-line microphone: -40dBsensitivity omnidirectional microphone

Using your headset

NOTE: There are Land Rmarkingson the earcups.
Connecting to smart devices
• Connect your headset'sanalog connector into your smart device such as
mobile phone or tablet PC.
• Use the in-line controllers
microphone.
Connecting to PCor MAC
1. Connect your headset'sanalog connector into the bundled Y-cable.
2. Connect the Y-cable'sheadphone connector to your computer's
headphone port.
Connect the Y-cable'smicrophone connector to your computer's
microphone port.
3. Youcan connect the bundled microphone boom to your headset.
NOTE: T hein-line microphone is disabled when the microphone
boom is connected.
4. Use the in-line controllers
microphone.
ASUS Cerberus
to increase/decrease the volume or mute the
to increase/decrease the volume or mute the
3
19/12/13