Technical Data - Jcm-Tech Micro-Dcs Bedienungsanleitung

1 Radio card connection
2 Jumper 12/24V
3 Programming /reset pushbutton
4 Operation led
5 Power

Technical Data

Frequency
Code memorisation
Memory
N. channels
Antenna
Connection of the access control input
Power supply
Range in 12V d.c.
Relay contacts
Power transformer
Sensitivity
Max power consumption
Power in network standby mode
Operating temperature
Watertight
Dimensions
* Depending on the proximity reader and of its configuration.
Requirements according to Ecodesign regulation
This equipment complies with the energy efficiency requirements established by the Ecodesign regulation.
The specific parameters are detailed below:
•Network standby mode: This device has a network standby mode that is automatically activated when the device is
powered on or after receiving a signal.
•Transition time to network standby mode: 1 second.
•Recommended power supply: For devices operating at 12/24Vac/dc, a power supply with an output of 12Vac/dc or
24Vac/dc, 0.5A should be used.
6 Memory card connection 126/500
8 Microswicht Imp/Biestable mode
9 Radio operation selector Y/N
10 Power led
433,92MHz / 868,35MHz
Self-learning or via programmer
31 codes / insertable 126/500 codes
jcmtechnologies
3
1 / 2
Built-in
No
12 / 24 V ac. dc.
11,8V - 13V
1 A / 125 V ac.
---
> - 100 dBm
75 mA
1,5W
-20ºC --- +55º C
IP 44
127 x 70 x 52 mm