DUROFIX RV2052-WR8 Produktinformationen Seite 19

21. Torque Calibration
User may calibrate the coefficient value ranged from
80% to 120% complied with their torque tester. The
default is 100%. Press
/ to adjust compensation value. Press
SAVE and EXIT.
Pattern of Fastening
Torque strategy is tool's default shut-off condition. Tool will shut-off when setting
torque is reached. If angle strategy is active, the tool will turn additional setting angle
degree to shut-off after setting torque reached.
Shift-down torque and shift-down speed are helpful to improve precision especially in
lower torque application. Tool starts in free speed setting value and turns to shift down
speed setting value while shift down torque setting value is reached. For example, the
initial speed is 500 rpm and torque target is 10Nm. If user set shift-down speed and
shift-down torque as 200 rpm and 5 Nm, the tool will start at 500 rpm, and go to 200
rpm when torque is reached 5Nm and shut-off in 10Nm. User may try to optimise shift-
down torque and shift-down speed to get better performance.
Troubleshooting
Code Description
E001 Over current
E002 Low Battery
E003
Battery
overheating
E004 Battery low
temp
E005 Electric
overheating
Note: if troubleshooting doesn't work, call authorised service centre.
NOTE
Only do tool and receiver be pairing during both set on the same Group and ID. Do not set
all tools or receivers on the same one Group and ID. More than two tools or receivers setting on the same
one Group and ID means they are in the same channel and users could not tell which signals come from
which tools.
1English1
to enter EDIT mode. Press
Troubleshooting
Detach and
reinstall battery
Change battery
Cool down or
change battery
Warm up or
change battery
Cool tool down
English
to
Code Description
E006 Electric short
E007 Motor stall
E008
Motor
overheating
E009 Strain gauge
fault
E999 Wrong
password
-18
Troubleshooting
Call service
centre
Detach and
reinstall battery
Cool tool down
Call service
centre
Call service
centre if forgot