Matrx HUG Montagehandbuch Seite 7

G C
The knitted fabric side of the headrest cover can be wiped with a damp absorbent towel, cloth,
or paper towel. Remove all gross contamination from surface (i.e. food particles, blood, bodily
fl uids). Spot-clean with mild soap and water.
®
Matrx infection control covers are polyurethane (PU) coated on the outer surface and are designed
for easy cleaning and disinfection.
C D
The infection control cover can be cleaned and disinfected with ready-to-use disinfecting wipes 3M,
Virox Accel TB, Accel Prevention, PREempt, OPTIM 33 TB, or other wipes with similar formulations.
Note that the surface should be cleaned fi rst, with all gross contamination (i.e. food particles, blood,
bodily fl uids) fi rst removed with absorbent material (cloth or paper towel). Ensure the coated surface of
the cover is clean by wiping with one of the 2-in-1 cleaning and disinfecting wipes mentioned above.
To disinfect, liberally wipe the surface with the ready-to-use disinfecting wipe again. Avoid pooling of
the disinfectant and ensure the disinfectant is distributed equally over the cover surface. Wipe dry after
recommended dwell time (refer to each disinfecting products manufacturing instructions). It is best
practice to wipe the surface with a damp cloth, mild soap, and fi nally a damp cloth no matter what
disinfectant is used.
M L
Headrest Cover: The outer cover may be removed and cleaned in a laundering machine. Care-
fully unzip the outer cover from the foam pad. To avoid possible damage to the cover, the zipper
of the cover should be closed prior to laundering, and covers should not come in contact with any
other sharp garment accessories. Wash at warm temperature not higher than 60°C (140F), using
neutral detergents such as Tide or Persil.
Hug Insert: The Hug Insert (quilted pad) may be removed and cleaned in a laundering machine on
a gentle cycle. Unzip and remove the outer cover from the Hug Headrest, then carefully remove
the Hug Insert from the headrest mounting plate. To protect the integrity of the quilted insert/
pad, ensure it does not come in contact with any other sharp garment accessories. Wash at warm
temperature not higher than 60°C (140F), using neutral detergents such as Tide or Persil.
D
Headrest Cover: Adequate drying is a crucial factor in the care and maintenance of the covers. The
covers should be dried completely prior to use. Air drying is the method of choice. DO NOT WRING
OUT. Hang cover and allow it to drip dry to minimize wrinkling. Alternatively, covers may be tumble-
dried on low/cool setting. Cushion covers should not be ironed or pressed.
Polyurethane (PU) coated fabrics can absorb liquids for short periods causing a temporary change to the PU
characteristics. The wet cover is more vulnerable to physical damage and should not be used until fully dried.
Hug Insert:
The Hug Insert contains non-absorbant, fast-drying StaminaFiber
drying is the method of choice. Hang the Hug Insert and allow it to drip dry. Alternatively, the Hug
Inserts may be tumble-dried on low/cool setting. Hug Inserts should not be ironed or pressed.
I
I
- 7 -
(for Infection Control Covers)
(C H I )
® material. Air