Matrx HUG Montagehandbuch Seite 6

2.2 INSTALLING THE HUG HEADREST
INSTALLATION INSTRUCTIONS (HUG HEADREST): (see Fig 1 below)
1. Position the headrest mounting collar over the pivot ball on the headrest mounting hardware (1);
2. Align and secure the mounting collar to the headrest pad (2) via mounting screws (x3) - see
IMPORTANT! note below.
IMPORTANT! Following installation or adjustment, ensure that ALL mounting screws are
properly aligned and threaded carefully into the headrest pad. Each screw should be installed
& tightened evenly to prevent risk of cross-threading, and to ensure the mounting collar is
properly secured to the headrest pad.
Fig. 1 Headrest Pad Installation
3.0 C
3.1 INSPECTION
WARNING! Risk of injury or damage
• Do not continue to use this product if problems or damage are discovered;
• Corrective maintenance can be performed at or arranged through your service provider
Frequent visual inspection of all components, including upholstery materials, foams (if accessible) and
any hardware or plastics, should be performed to identify any breakage, deformation, punctures,
wear and tear or compression. Replace damaged/worn components if necessary.
3.2 CLEANING AND DISINFECTION OF COVERS
WARNING! Risk of damage
To avoid infectious exposure, inspect cushion thoroughly and properly clean and disinfect
any materials soiled with blood or other bodily fl uids
CAUTION! Risk of damage
• DO NOT use cleaning and disinfecting agents with abrasive, staining, or polymer-damaging
properties such as phenols, alcohols, or bleaches. Chlorine solutions used even in low
concentrations on a regular basis can diminish the life of the cover.
• Chosen cleaning agents and disinfectants must be compatible with one another in order to
effectively protect the materials on which they are applied.
• Keep clear of open heat sources during cleaning.
• DO NOT use fabric softener when laundering the Hug insert.
1
M
2
.
- 6 -