Matrx HUG Montagehandbuch Seite 5

Hug Headrests are designed for use with our line of Matrx
LOXX ™ hardware, and are also compatible for use with most industry standard (OEM) headest
mounting hardware that utilizes a 1" (25mm) pivot ball.
sold separately)
IMPORTANT! Be certain to also read through the OEM User Manual for the Headrest
Mounting Hardware (sold separately), for additional safety information and warnings related to
the installation and maintenance of the headrest hardware.
H H
ESP15-HUG
ESP15-HUG Matrx Hug Standard Pad 15cm x 9cm w/ Startex® cover
ESP26-HUG Matrx Hug Standard Pad 26cm x 9cm w/ Startex® cover
ESP36-HUG Matrx Hug Standard Pad 36cm x 9cm w/ Startex® cover
ESP15-IC-HUG Matrx Hug Standard Pad 15cm x 9cm w/ Infection Control cover
ESP26-IC-HUG Matrx Hug Standard Pad 26cm x 9cm w/ Infection Control cover
ESP36-IC-HUG Matrx Hug Standard Pad 36cm x 9cm w/ Infection Control cover
HUG-HRPAD15 Matrx Hug 15cm Headrest Insert only*
HUG-HRPAD26 Matrx Hug 26cm Headrest Insert only*
HUG-HRPAD36 Matrx Hug 36cm Headrest Insert only*
*Note: Hug Inserts are available as replacement to the molded green foam inside the corresponding Elan Headrest Pad.
2.1 INSTALLING THE HUG INSERT
NOTE: The Hug Insert may be installed as a replacement to the green foam pad in our
Matrx ® Elan Headrests. Prior to installation, you must remove the existing outer headrest
cover, then carefully remove the molded green foam pad from the headrest mounting plate.
INSTALLATION INSTRUCTIONS (HUG INSERT):
1. Carefully install the hug insert (pad) (1) onto the headrest mounting plate (2) (Note: the rear
fl aps on the hug insert can be stretched to fi t around the headrest mounting plate)
2. Ensure the insert/pad is properly fi tted and centered on the headrest mounting plate (3), then
re-install the outer headrest cover and close the zippers (4).
(REAR VIEW)
1
2
P /I
ESP26-HUG
® Elan Headrest Hardware, and our Matrx
(Note: Headrest mounting hardware is
ESP36-HUG
3
4
- 5 -
®