HOMCOM 834-849V02 Bedienungsanleitung Seite 5

CLOCK INSTRUCTION
Button A: Time setting confirmation/reset button.
Button B: Switch display/increase value button.
Set the clock:
• Press A to enter the setting mode (the
firsttime) to enter the time adjustment. At
this time,Minutes starts to blink. Press B to
increase thevalue and adjust the value from
00 to 59.
• Press A for the second time. At this time,
Hour starts to blink. Press B to increase the
value and adjust the range from 00 to 23.
• Short press A (the third time) to enter the date adjustment, at this time "day" begins
to blink, press B to increase the value, adjustment range 1-31.
• Short press A (the fourth time) At this time "month" begins to blink, press B to
increase the value, adjust the range 1-12.
• Press A for the fifth time. At this time, "Year" starts to blink. Press B to increase the
value and adjust the range from 2020-2059.
• Press button A briefly (sixth time) to enter temperature calibration setting, [Ac: xx],
where xx represents the calibration value. Press button B to increase, positive
numbers indicate increase, negative numbers indicate decrease. Adjustment range
is -5 to 5, in degrees. (Note: If the probe is not plugged in, it will automatically skip
to the seventh setting).
• Press button A briefly (seventh time) to enter alternating display interval setting [dF:
xx], where xx represents the cycle time. The default is 6 seconds. Press button B to
increase the value; the larger the value, the longer the interval. Adjustable time is 1-
9 seconds.
• Press button A briefly (eighth time) to enter brightness setting [LL: xx], where xx
represents the brightness value. Adjustment range is 1-3.
• Press button A briefly (ninth time) to enter automatic brightness setting [AL: xx],
where xx represents the switch value. A value of 0 turns off automatic brightness.
The screen brightness will display according to the brightness setting value. A value
of 1 turns on automatic brightness, with the clock brightness automatically
becoming LL:1 mode from 7:00 PM to 6:00 AM. From 6:00 AM to 7:00 PM, it will
display according to the brightness setting value.
• Short press the A key (tenth time), save all the set values, clock seconds count clear
0 and return to the normal display state.
Switch display items:
Short press button B to switch display mode.
Mode B1: Only shows time
Mode B2: Only shows temperature
Mode B3: Only shows date
Mode B4: Shows time and temperature, with an interval time of 6 seconds (adjustable
by A7 setting) (Note: Date display is removed)
Display content: Year, month, day, hour, minute, temperature, etc.
Independent timing accuracy: ≤±0.2S/ day
5