Operation - PeakTech 6070 Bedienungsanleitung

5. Operation

5.1. Adjusting the output voltage
Direct entry
Proceed as described to adjust the output voltage:
1.) Switch on the device.
2.) Press the [V] key. The LED display indicates 00.00 and the first digit flashes.
3.) Press the appropriate number keys to enter the desired voltage value.
4.) If an incorrect entry be carried out, use the [Del] key (Correction key), the previous entry is
rejected and you can repeat your entry.
5.) Pressing the [Enter] button will confirm and save the entry.
Example 1:
Setting 5.99V
1.) Press the [V]-key.
Sequentially, press the number keys [0][5][9][9] and then [ENTER] to save the entry or ...
2.)
3.) Press the [V]-key and then sequentially the number keys [5] [.] [9] [9] and then press the
[ENTER] key to confirm and save the entry.
Example 2:
Setting 29.99 V
1.) Press the [V]-key.
2.) Sequentially, press the number keys [2][9][9][9] and then [ENTER] to save the entry or ...
3.) Press the [V]-key and then sequentially the number keys [2] [9] [.] [9] [9] and then press the
[ENTER] key to confirm and save the entry.
Entering the output voltage in 0.1V / 1V steps
Additionally, it is possible to change the output voltage using the numeric keys 4 and 9 to change the
voltage value in +/- 0.1V steps.
If the keys were pressed and hold, the output voltage will change the voltage level continuously in
0.1V steps.
Use the number keys 5 and 0, the voltage value can change by +/- 1V.
If the keys were pressed and hold, the output voltage will change the voltage level continuously in 1V
steps.
-13-