LesMills SMARTBAR UPRIGHT VERTICAL STORAGE RACK Montage- Und Gebrauchsanleitung Seite 7

English
ASSEMBLY AND INSTALLATION INSTRUCTIONS (continued)
Rack Assembly
STEP 1 Insert the Lower frame 2 into the Base 1. Ensuring the frame is correctly orientated as per the
illustration (with the two large holes facing towards the logo on the Base). Fasten with six M6 x 10 screws 8
using the M6 Allen key 13.
STEP 2 Inert the Middle frame 3 into the Lower frame 2. Ensuring the frame is correctly orientated as per the
illustration (with the two large holes facing towards the logo on the Base). Fasten with six M6 x 10 screws 8.
STEP 3 Insert the Upper frame 4 into the Middle frame 3. Ensuring the frame is correctly orientated as per
the illustration (with the two large holes facing towards the logo on the Base). Fasten with six M6 x 10 screws
8.
STEP 4 Attach Weight Hanger 5 to the lowest position and fasten with two M6 x 40mm screws 9.
Repeat this step for the other two Weight Hangers.
STEP 5 Attach the two Side hooks 6 to each indicated location and fasten with two M4 x 8mm screws 10.
STEP 6 Attach the Anti-tip Strap 7 to the rear of the Upper frame 4, behind the Weight Hanger with one M6
x 10mm screws 8.
STEP 7 Check all fasteners are fully tightened and there is no movement between the parts.
WARNING: FAILURE TO INSTALL THE ANTI-TIP STRAP COULD RESULT IN SERIOUS INJURY OR
DEATH.
Please now install the UPRIGHT VERTICAL STORAGE rack to the wall as per the assembly instructions
under ANTI-TIP STRAP INSTALLATION TO THE WALL (P5.)
4