Azdome M17 Pro Bedienungsanleitung Seite 7

8. Install the Rear Camera in Your Vehicle.
Here are three examples of how to guide the rear camera wire:
Plug the rear camera cable into the AV
INput socket on the front camera.
①
③
Install Rear Camera
8.1. Choose a flat and central location near
the number plate lamp at the rear of your
vehicle to mount the camera.
8.2. Attach tape to the camera bracket to hold
it in position while installing it. Then, drill two
small holes: one for the first screw and the
second to run the reverse camera cable
through.
09
Conect the red wire
of the camera to the
reversing light.
②
8.3. Use a screwdriver to secure the first
screw, but leave it loose enough so that you
can adjust the camera as needed.
8.4. Thread the camera wire through the hole that you drilled and
check the installation position.
8.5. Mark the location that is suitable for the second screw and drill
a small hole for it.
8.6. Securely tighten both screws to fix the
camera in place.
8.7. Once the installation is completed, connect the rear plug to the
rear camera interface on the recorder. Then, connect the red reverse
line on the extension line of the rear camera to the positive pole on
the reverse light.
To Reversing Light( +12V Red )
8.8. Adjust the position of the lens to ensure that it is level with the
ground.
8.9. Start the engine and check that the machine is installed
correctly.
Car Cigarette Lighter
Rear Cam
10