VEVOR UC19S-EH30 Bedienungsanleitung Seite 17

• This range hood is factory set for
venting through the roof or wall.
・ Duct work can terminate either
through the roof or wall. To vent
through a wall, a 90° elbow is
needed.
IMPORTANT:
• NEVER exhaust air or terminate
duct work into spaces
walls, crawl spaces,
attics or garages.
must be vented to the outside.
• Use metal/aluminum duct work
only.
• Fasten all connections with
sheet metal screws and tape all
joints with certified Aluminum
Tape.
• Use caulking to seal exterior wall
or roof opening around the cap.
• Colder climates require wrapping
insulation around the ducts and
optional blowers.
• The system must have a
Backdraft Damper.
*Minimum height: 77"
(70 %"
from bottom of duct to ground
when range height to stove is 24"
(76 %"
from bottom of duct to ground
when range height to stove is 30"
①
Wall Vent
(2)
Roof Vent
* Due to different ceiling height configurations, recommended height may not be applicable.
VENTING METHODS
，，
6
Duct
between
ceiling,
All exhaust
①
for 6"- 0 Transition)
，，
Min height: 83
for 6"- 0 Transition)
Optional Backdraft
Damper
Wrap insulation required
-0
for cold climates
(Rectangular Exhaust Connector
to circular transition; typical height)
，，
Min: 24
Max: 30"
17
8"
6"
(6''- 0 Transition /
、
〜
typical height) /
w
36
typical
，，
7%