FEDERAL COMMUNICATIONS
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to Part 15 of the FCCrules. Theselimits are designed to provide reasonable protection against
harmful interference in aresidential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may causeharmfui
interference to radio communications. However, there i5 no guarantee that interference wilt not occur
in a particular
installation.
If this equipment
reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment
into an outlet on a circuit different
con nected.
Consult the dealer or an experienced radiofTV technician for help.
Use only shielded cables or connect 1/0 devices to this equipment.
You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
This device complies With requirementOf EMCdirective 89/336/EEC with regardto Electromagnetic
Compatibility, and 73/23/EECand 93/68/EECwith regard to Low Voltage directive.
COMMISSION
(F.C.C.) STATEMENT
does cause harmful interference
from that to which the receiver is
to radio or television