Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Accessories
① 1PC x Front handle frame (smaller one)
② 2PCS x Front frame for wheels
③ 4PCS x Wheels
④ 2SETS x M8 Screw, washer and locknut set
⑤ 4PCS x Clamping piece
⑥ 2SETS x M10 Screw, washer and locknut set
⑦ 2PCS x Adaptor with spring
⑧ 2PCS x R pin
Assembly instructions
Step 1: Assemble the wheels ③ on both sides of the frame ② and then Insert both pieces
of frames with wheels into the main frame①.
Step 2: Push M8 screws through the holes of clamping pieces ⑤ and frame, make sure
that the connecting part are covered with clamping pieces on both sides. Then add
washers and use tools to tighten with the locknuts.
Step 3: Insert adaptors ⑦ on the top of both frames with wheels, then lock them with the R
pins⑧.
Operation/Guide to using
1. Roll the stand and make sure your motorcycle front wheel is in the middle of the frame.
2. Rise the stand with circled handle and make the adaptors right positioned under the
bottom of both sides of motorcycle front forks
3. With the adaptors securely supporting the bottom of motorcycle front fork, lower the
stand frame onto the ground.
Important
Always keep this stand away from children.
Check the stand is in good condition before using it.
Motorcycle Front Stand
2
Werbung
