Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Accessories
A 1PC Rear handle frame (bigger one)
B 2PCS Rear frame for wheels
C 2SETS M8 Screw, washer and locknut set
D 4PCS Black Wheels
E 2SETS M10 Screw, washer and locknut set
F 2PCS Screw with plastic topper
G 4PCS Clamping piece
H 2PCS Fork adaptors
I 2PCS Paddle adaptors
Assembly instructions
Step 1: Assemble the wheels (D) on both sides of the frame (B) and then insert both pieces
of frames with wheels into the rear handle frame (A).
Step 1: Push M8 screws through the holes of clamping pieces (G) and frame, make sure
that the connecting part are covered with clamping pieces on both sides. Then add
washers and use tools to tighten with the locknuts.
Step 1: Loose both sides screws (F) on the top of the frame with wheels, insert the correct
adaptors of paddle adaptors (I) or fork adaptors (H) which can fit your motorcycle.
Operation of the stand with paddle adaptors
1. Loose the screws on the top so that the position of adaptors can be adjusted.
2. Roll the stand and make sure your motorcycle rear wheel is in the middle of the frame.
3. Adjust the position of the paddle adaptors to match the width of your motorcycle dual
swing arm and then tighten the screw with plastic.
4. Rise the stand with handle and move the stand to where are under the swing arm, then
press down the stand in order to rise your motorcycle rear wheel. Make sure the paddle
adaptors are snug up against the swing arm.
Operation of the stand with fork adaptors
1. Loose the screws on the top so that the position of adaptors can be adjusted.
2. Roll the stand and make sure your motorcycle rear wheel is in the middle of the frame.
3. Adjust the position of the fork adaptors to match the width of your motorcycle bobbins on
both sides and then tighten the screw with plastic.
4. Rise the stand with circled handle and move the stand to where fork adaptors are right
under the bobbins, then press down the stand in order to rise your motorcycle rear
wheel. Make sure the fork adaptors are snug up against the bobbins.
Important
Always keep this stand away from children.
Check the stand is in good condition before using it.
Motorcycle Rear Stand
3
Werbung
