Kemper 104998 Anleitung Für Die Montage Seite 11

1. WARNING: In order to avoid accidental fire due to combustion of grease collected in the tray, clean the tray
after every use and fill it with water before every use.
2. Place the hot plate on a stable and horizontal surface. Do not alongside two or more burners.
3. Place the hot plate far from inflammables substances or things that could be damaged by heat.
4. Make sure that the hot plate tap is CLOSED - Tap on position "OFF" (clockwise rotation).
5. Make sure that the seals are in a good state before connecting the gas cartridge
(see figure).
6. Never use the appliance with damaged or worn seals.
7. Check that the appliance is not damaged. Never use a damaged appliance.
8. Put the cartridge in its slot, placing the cut on its neck in correspondence to the
safety stop.
9. Place the lever connecting the cartridge on the "LOCK" position (fig. 2).
ATTENTION: the appliance is now ready for use. The positioning of the lever on "LOCK" presupposes the
immediate ignition of the stove as the gas circuit is ready for gas supply. Do not leave the appliance
unattended and without flame with the lever positioned on "LOCK".
Fig. 1
10. Turn anticlockwise all the way the tap until it is positioned on "
11. If the stove dose not light, turn the control knob back to "OFF" position and repeat.
12. If after three failed attempts, the stove dose not light, turn the control knob to the "OFF position and move the cartridge
lever to the "RELEASE" position.
13. Open the cartridge cover and remove the cartridge, Shake the cartridge to see if it is empty. If empty, replace the
cartridge and repeat from point 9.
14. Regulate the flame according to your needs.
15. Caution: the appliance does not have a flame supervision device. Do not leave the appliance unattended during use.
16. It is recommended to cook food with a thickness not exceeding 1.5-2 cm.
SHUTTING DOWN THE APPLIANCE
1. To turn off the fire, rotate completely clockwise the tap to the "OFF" position and wait until the flame is fully extinguished
before performing the next step.
2. Position the cartridge-connecting lever on the "RELEASE" position and remove the gas cartridge from the
compartment.
3. Wait for the plate to cool before storing it.
4. When the appliance is not in use, it is compulsory to take the cartridge out of the appliance.
5. This unit can be kept inside only if the cartridge has been disconnected and removed from the appliance. If you expect
that the barbeque remains unused for a certain period of time, store it in its original packaging and in an environment
free from dust.
CHANGING THE CARTRIDGE
1. Check that burners are extinguished before disconnecting the gas cartridge. Be careful the gas cartridge could be hot.
2. Ensure that the cartridge is empty before replacing it (shake it in order to hear the sound produced by the liquid).
3. Replace the cartridge outside and away from other people.
4. Make sure that the tap of the hot plate is CLOSED. Tap on "OFF" position (clockwise rotation).
5. Check that the cartridge connection lever is on the "RELEASE" position.
6. Open the cartridge holder lid and take out the cartridge.
7. Check that the seals are in a good state of maintenance.
Put the cartridge in its housing placing the cut on the cartridge's neck in correspondence to the safety stop.
8.
9. Position the connecting lever on the "LOCK" position.
CLEANING AND MAINTENANCE
Clean your equipment after EVERY USE. Do not use abrasive or flammable detergents, which may damage the
components of the unit and may cause a fire. Clean with a solution of warm water and soap.
NEVER USE THE PRODUCTS FOR OVEN CLEANING.
CAUTION: All cleaning and maintenance operations, should be made when the unit is cold and after removing the cartridge.
EXTERNAL SURFACE: wash with a soft cloth and a solution of warm water and soap. Rinse with water. Do not use
abrasive cleaners, degreasers or concentrated products for cleaning of barbecues.
Use a solution of gentle detergent or baking soda and hot water. In case of stubborn stains, use a non-abrasive detergent
powder and then rinse with water.
BOTTOM OF THE BARBECUE DRIP: the tray should be cleaned after each use in order to prevent that accumulation of
grease can ignite causing a flash fire. Remove residuals with a brush, a scraper and / or a sponge and then wash with a
solution of water and soap. Rinse with water and let dry.
PLASTIC SURFACES: wash with a soft cloth and a solution of warm water and soap. Rinse with water. Do not use on
plastic surfaces abrasive cleaners, degreasers or concentrated products for barbecue cleaning.
DT Istr 104998 – 09/18_REV.7_09/24
" position; continue the rotation until ignition occurs.
104998
Fig. 2
11/72