Cabletech UCH0122 Bedienungsanleitung Seite 6

Installation
o
SOLID BRICK AND CONCRETE
• When installing wall mounts on cinder block, verify that you have a minimum of 1-3/8" of actual
concrete thickness in the
joints! Be sure to mount in a solid part of the block, generally
block. It is suggested electric
drill to avoid breaking out the back of the hole when entering a void or cavity.
• Installer must verify that the supporting surface will safely support the combined load of the
equipment and all attached
• Use the Wall Plate as a template to mark two holes locations on the wall, as shown in fig. I .2.
• Pre-drill these holes with a 8mm masonry bit to at least 50mm in depth. Insert a Concrete Anchor (W-B)
into each of these holes. Attach
_CRBLETECH
User manual
stud
BLOCK MOUNTING
A WARNING
hole to be used for the concrete
drill on slow setting is used to drill the hole instead
hardware and components.
the Wall Plate to the wall using two wood
6
anchors. Do not drill into mortar
1" minimum from the side of the
of a hammer
screws (W-A) as shown
fig. 1.1
in fig. 1.3.