Cabletech UCH0122 Bedienungsanleitung Seite 5

Installation
Open the decorative covers from the speaker wall plate to easy for installation,as
. WOOD STUD WALL
• Make sure that the supporting surface will safely support the combined load of the equipment
and all attached hardware
• Tighten wood screws firmly, but do not over tighten. Over tightening can damage the screws,
greatly reducing their holding
• Make sure that mounting screws are anchored into the center of the studs. Use of an "edge to
edge" stud finder is highly recommended.
• Hardware provided is for attachment
into studs. Installers are responsible to provide hardware for other types of mounting situations.
Use a stud finder to locate the edges of the studs.
recommended. Based on their edges, draw a vertical line down each stud's center. Place wall plate on wall
as a template. And mark the center of the two mounting holes. Make sure that the mounting holes are on
the stud centerline. Drill two 1/8" (3mm)
secure it using two lag bolts (W-A) as shown in fig. 1.1
_CRBLETECH
User manual
A WARNING
Becareful not to damage the
decorative covers when you
open them,
MOUNTING
A WARNING
and components.
power.
of mount through
Use of an edge-to-edge
dia. Holes 1.2" (30mm)
5
shown in below.
standard thickness drywall
stud finder is highly
deep, Make sure that the wall plate is level,
or plaster