One for All Smart Control 8 Bedienungsanleitung Seite 9

ON REMOTE SETUP
B SET UP BY CODE
If your brand is not listed in section A, you can set up your device by
trying codes individually. To do this:
1.
Turn your device on (not on standby).
2.
3.
4.
5.
6.
7.
8.
If the device turns o , your remote is ready to use. If not, repeat
steps 3-7 with the next code in the list.
* Some codes are quite similar. If you nd that one or more keys
do not operate as you expect, try again from step 3 with the next
code in the list.
Locate the brand of your device in the code
list. Codes are listed by Device Type and
Brand.
Hold down SETUP until the LED under the
device blinks twice.
The LED under the current mode key will
stay lit.
Press the DEVICES key repeatedly until the
LED for the device you want to set up is lit.
Enter the rst 5 digit code listed for your
brand (e.g. 06351 for a Blue Sky TV).
The LED will blink twice and go out.
Now aim the remote towards your device and
press the POWER key.
9