byox RUMBLE Gebrauchsanleitung Seite 11

to the height you want. After hearing "click", make sure that the button is visible through the corresponding
opening at the height you have selected. Re-tighten the bracket. The scooter has three height positions.
•
MUSIC AND LIGHTS – FIGURE 3: At the bottom of the scooter base is located a button to activate the scooter's
music/light functions.
•
USE THE SCOOTER WITH A SEAT: To unfold the saddle, press the seat lock button (4) and pull the saddle down.
ADJUSTING THE POSITION OF THE FOLDED SADDLE ON THE HANDLEBAR STEM: In the folded position the saddle
can be in front or behind the handlebar stem when riding the scooter in the upright position. To position the
saddle in front or rear of the handlebar stem, press the seat lock button (4) and turn the saddle in the desired
position.
RIDING THE SCOOTER - FIGURE C
Riding the scooter can be dangerous activity. Scooters can and are intended to move and for that reason it is possible for
you to find yourself in dangerous situations and / or loss of control and / or falling. This may lead to serious injuries or
EVEN death, when inappropriate safety measures are used.
First start practicing in an area where there are no other participants in traffic or ask someone to lead you through your
first steps.
Sudden moves and twisting of the upper part of the body may lead to loss of balance.
1.Hold the handles with your hands, place one foot on the platform and the other on the ground.
2.Pay attention to your surroundings and make sure that the place you are going to ride is clear.
3.Push with one foot at the side of the scooter in order to give it a boost.
4.Turn the handlebar to the left or right, in order to turn.
5.Repeat this action of pushing, in order to keep moving.
6.In order to stop or slow down, put the foot that pushes the scooter on the ground. If you tilt too much to the left or
right, you can turn the scooter and fall. The scooter does not have a starting device and a stopper.
7.Practice balancing on the scooter before you start riding it.
STOPPING WITH THE SCOOTER – FIGURE D
The scooter does not have a starting device. It has a stopping device, which does not activate automatically. Stopping is
an important skill and must be acquired in time. Never lift your hands - hold the handlebar firmly.
1.Make sure that you hold the handlebar firmly with both hands and move in a straight line. Slide one foot back towards
the rear wheel of the scooter. 2. With the heel of this foot gradually apply pressure on the brake mechanism. This will
reduce the speed and will finally lead to stopping of the scooter.
WARNING! The breaking mechanism can get heated during use. DO NOT touch the brake after stopping! While using
the brake never touch it or the wheels – during continuous use for reduction of the speed and during stopping their
temperature rises and you may burn your hands!
INSTRUCTIONS AND WARNINGS FOR WORKING WITH BATTERIES
Find the battery compartment cover, which is located on the underside of the scooter. Use a screwdriver to loosen the
cap screws. Take it off. Insert 3 *1.5 V type AA alkaline batteries (not included), observing the polarity marked on the
bottom of the compartment. Put the battery cover back on and tighten the screws with a screwdriver. Do not
overtighten. To remove the batteries, repeat the steps.
WARNING!
1.When placing the batteries, children should not be present!
2. The batteries are not included in the set.
3. The batteries should be handled by an adult only. Do not allow the children to play with the batteries.
4. Always remove the discharged batteries and do not throw them away with the household waste, use the places
designated for that purpose. They are recyclable.
5. Use АА batteries only. Alkaline batteries are recommended.
6. Always remove the batteries, if you will not use the product for a long period of time.
7. When you replace the batteries always replace them with new ones, always replace all batteries. Children should not
be present while you are replacing the batteries.Do not mix old batteries with new ones.
8. Do not mix alkaline, standard (Carbon - Zinc), or rechargeable (Nickel – Cadmium) batteries.
9. Do not throw the batteries in fire, because they may blow up or leak.
INSTRUCTIONS FOR USE
Before each use, make sure that:
•
The scooter is correctly assembled, and handlebar is correctly adjusted.
11