Dell PowerConnect J-SRX210 Schnellstart Handbuch Seite 4

M 2: O A S IP A
ETHOD BTAINING TATIC
Use the ge-0/0/0 port to connect to your ISP. Your ISP will have provided a static IP
address. You will not receive an IP address using the DHCP process.
If you are using this method to obtain an IP address on your services gateway, follow
the instructions from Part 7 to Part 10 in this document.
Part 7: Access the J-Web Interface
1. Launch a Web browser on the management device.
2. Enter http://192.168.1.1 in the URL address field. The J-Web login page is
displayed.
3. Specify the default user name as root. Do not enter any value in the Password field.
4. Click Log In. The J-Web Initial Setup page is displayed.
Part 8: Configure the Basic Settings
Configure the basic settings, such as Host Name, Domain Name, and Root Password for
your services gateway.
IMPORTANT: Ensure that you have configured the IP address and root password before
you apply the configuration.
NOTE:
All fields marked with an asterisk (*) are mandatory.
If you have used Method 2 in Part 6 to obtain an IP address on your services gateway,
ensure that you make the following J-Web modifications:
1. Unselect the Enable DHCP on ge-0/0/0.0 check box.
Y S G
DDRESS ON OUR ERVICES ATEWAY
2. Enter the manual IP address provided by your ISP in the ge-0/0/0.0 address field.
The IP address must be entered in the
mask.
3. Enter the IP address of the gateway in the Default Gateway field. The IP address for
the gateway is also provided by the ISP.
4. Enter server names in the DNS name servers field. The server names will be
provided by your ISP.
5. Apply the configuration.
Part 9: Apply the Basic Configuration
1. Click Commit to save the basic configuration.
2. Click Apply to apply the basic configuration.
NOTE:
To make any changes to the interface configuration, see the Branch SRX Series
Services Gateways Golden Configurations at
http://www.juniper.net/us/en/local/pdf/app-notes/3500153-en.pdf.
Part 10: Verify the Configuration
Access http://www.support.dell.com to ensure that you are connected to the internet.
This connectivity ensures that you can pass traffic through the services gateway.
NOTE:
If the http://www.support.dell.com page does not load, verify your configuration
settings, and ensure that you have applied the configuration.
After you have completed these steps, you can pass traffic from any trust port to the
untrust port.
Connecting and Configuring the J-SRX210 Services Gateway with
Integrated Convergence Services
If you have a J-SRX210H-P-MGW model, use the instructions below to configure voice
support on the media gateway and get started using your device to place and receive
calls.
The following table provides an overview of the steps you must follow to configure voice
support on the media gateway.
Step Task
1 Connect the FXO and FXS ports.
2 Access the J-Web interface.
3 Configure the class of restriction.
4 Configure the SIP station.
5 Configure the analog station.
6 Configure the peer call server.
format, where is the subnet
a.b.c.d/xx xx
Step Task
7 Configure the trunk.
8 Configure trunk groups.
9 Create the dial plan.
10 Configure the media gateway.
11 Configure the survivable call server.
Page
4