Free2Move eSolutions eProWallbox Move Bedienungsanleitung Seite 178

6.3 Charging in Authentication mode (Autostart disabled
and connected)
If the Authentication Operating Mode is configured, the charging session should
be authorised via the
available only when
•
The LED bar of the appliance should be solid blue, meaning
Move
colours).
•
Insert the plug of the charging cable into the socket on the device, until it
is fully engaged.
•
Insert the plug of the Type 2 cable in the charge port of the electric vehicle.
•
If eProWallbox Move
•
Charge the vehicle.
•
When charging is complete or the charging process needs to be stopped,
there are two possible ways to stop the charging session:
•
From the vehicle (e.g. unlocking the doors), then unplug the connector
from the vehicle and from
•
From
from the vehicle and from
•
The product returns to its initial state, ready for a new charging session.
CAUTION
At the end of the charging sessions, unplug the charging cable from
both the appliance and the vehicle and store it in a safe place.
eSolutions Charging
eProWallbox Move
is ready for charging (see Chapter 5.4
is connected to Wi-Fi, start remotely via app.
eSolutions Charging
Devices
Via Corradori 22 - Milano
00:02:30 :02:30
View more
CHARGING
DELAY DELAY S TOP S STOP
app. Authorisation through app is
is connected to Wi-Fi.
eProWallbox Move
eProWallbox Move
app, press STOP and remove the connector
eProWallbox Move.
22
U ser M an ual
eProWallbox
LED bar