Olympia A 350 Combo Bedienungsanleitung Seite 17

Transport rollers
Clean the transport rollers if you have removed a jammed laminating film or if the output laminating
film contains adhesive residue.
1
Switch the appliance to HOT using the hot/cold switch.
2 Switch the device on using the ON/OFF switch.
3 The indicator light Power is on. The device is not yet ready for operation. The appliance heats up.
4 After about 5 minutes, the LED display lights up Ready and the device is ready for operation.
5 Feed a sheet of paper straight into the feed area until the paper is caught by the transport rollers.
6
The paper is automatically pulled through the device. Adhesive residue on the transport rollers is
absorbed by the paper.
Caution! Risk of burns due to hot residues! The paper used for cleaning may contain hot
residues. The paper is very hot immediately after cleaning. When removing the paper, only
touch the cooled end.
7
Remove the paper at the cooled end.
8 Repeat the process with a clean sheet of paper until there are no more adhesive residues on it.
Troubleshooting
Malfunction
The device does not start
The appliance does not heat (any more)
The device does not laminate or does
not laminate correctly
The laminated foil is not completely
transparent.
The knife does not cut or not cut prop-
erly
The corner rounder does not punch
correctly
Solution
Check that the mains plug is plugged in correctly.
If the temperature is too high, the overheating protection
function switches on automatically. Allow the appliance to
cool down sufficiently.
Check whether you are using the correct function depend-
ing on the laminating film used (80 mic or 125 mic).
Clean the transport rollers.
Laminate the same film again to improve the result.
Check the material to be cut and the maximum capacity.
Check whether there is any material residue under the
guide rail.
Check whether there are any material residues in the
corner rounding.
17