Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Notes on laminating film
•
Only use film types intended for lamination.
•
Other types of film, such as transparent film, are expressly not suitable for lamination.
•
Select the size of the laminating film to suit the material to be laminated.
•
Do not adjust laminating foils to size before laminating.
Notes on the laminating process
•
Do not insert laminating film without contents into the feed area (front) of the laminator.
•
Do not insert the laminating film rolled up into the feed area (front) of the laminator.
•
Do not insert the laminating film on one side into the feed area (front) of the laminator.
•
Always insert the laminating film with the closed side first - centred and in a straight line - into the
feed area (front) of the ready-to-use laminator.
•
Do not pull the laminating film out of the output side (reverse side) during lamination.
Laminating (Hot)
Warning! Danger due to unexpected start-up! Make sure that the appliance is switched off
before connecting it to the mains.
1
Connect the power plug to a properly installed socket.
2
Switch the appliance to HOT using the hot/cold switch.
3
Switch the device on using the ON/OFF switch.
4
The indicator light Power is on. The device is not yet ready for operation. The appliance heats up.
Caution! Risk of burns due to hot appliance surface! Do not touch the surface of the
appliance during or immediately after operation.
Note: Wait until the appliance is fully heated up. Do not insert the laminating film beforehand, as this
will prevent it from fusing properly.
5
Place the document to be laminated in the laminating film. Make sure that there is a gap of ap-
prox. 3 - 5 mm to the edge of the film on all sides.
Attention! Material damage possible! Only use laminating films that are suitable for hot
lamination.
6
After about 5 minutes, the LED display lights up Ready and the device is ready for operation.
Attention! Material damage possible! Never insert the lamination foils at an angle into the
feed area.
Attention! Material damage possible! Always insert the closed end of the laminating
pouches into the laminator's feed area first.
Note: Make sure that the laminating film can be dispensed from the back of the device.
7
Guide the laminating film with the closed side straight into the feed area until the laminating film is
caught by the transport rollers.
8
The laminating film is automatically pulled through the device.
14
Werbung
