Venjakob TAGENA Aufbauanleitung Seite 2

55071-11
Assembly instructions "TAGENA":
Body & frame assembly
The fixture materials provided with this product (dowels and screws) are only suitable for fixing parts to concrete and/or solid masonry. Please observe the
maximum load that the wall-mounted elements can carry. Ideally, the suitability of the wall should be enquired about when the order is made and must be
checked by specialist staff before the cabinet is assembled at the latest. If the condition of the wall is not suitable (e.g. if it is a lightweight partition wall),
then another type of fixture suitable for the load that is to be carried should be used. Check the electrical input of any connection or device technology.
Free-hanging light fixtures require cable duct solutions that are either on or under plaster.
Please read and follow all assembly instructions carefully.
For reasons of weight, it is advisable to dismantle front parts such as doors
and drawers when transporting the furniture.
Transportation and assembly should always be carried out by two people!
1. Remove the transport protection & the transport lock underneath
the furniture packages.
Remove the packaging of the frame packages.
Remove all front parts to prevent damage during assembly.
Only reinstall the front parts as the last assembly step.
3. Use black furniture handle screws M4x20mm (Part No.51264) to
fasten the side frames on the body from the inside. To do so, screw
the screws (recommendation: use a handheld screwdriver size PZ2)
into the brass sleeves of the side parts.
Attention: Observe the marking for up and down!
5. All further assembly steps can be found in the "Stand elements" assembly instructions.
Alfons Venjakob GmbH Co. KG
Friedrichsdorfer Str. 220
33335 Gütersloh, Germany
2. Connecting the bodies to each other:
Variant A: Connection of the bodies by means of pan head screws
4x30mm (Part No.51266), with pre-drilling of the bodies on one side.
Variant B: Connection of the bodies by means of furniture screw
M4x15mm (Part No.51283) and threaded sleeve M4 5x22mm (Part
No.51285) with pre-drilling on both sides or drill through the pre-
drilled holes using a ø5mm drill (to protect against tearing, hold on
a piece of wood or similar on the other side!).
Attention: Select the body connection so that no screw heads are
visible in glass compartments.
4. 1. Connect the upper and lower frames to the side frames. To do
this, push the pins of the corner nodes into the frame profiles of the
side panels and fix them in the side frame using the pre-assembled
grub screw. Use the supplied Allen key SW 2.5 (Part No.50808) for
this purpose.
2. Then connect the upper and, if applicable, the lower base to the
body. To do this, screw the M4x20mm furniture handle screw (Part
No.51264) from the inside into the brass sleeves in the upper sheet
(recommendation: use a handheld screwdriver size PZ2).
Attention: If lighting has been installed, be careful not to kink,
squeeze cables, etc.
E-Mail: venjako@venjakob-moebel.de
Tel.: +49 52 09 5 92-0
Variant A
1.
Variant B
2.
Erstellt am: 14.05.2025
2 / 2