VEVOR SCA-30W Bedienungsanleitung Seite 10

1. Adjust present time:
Press "H" to adjust the hour until the figure comes stable, then press "M" to
adjust minutes
2. Set temperature:
Press "P" to set temperature, then press"▲" or "▼"to control the
temperature until the figure comes stable after about 3 seconds(setting
range 35-110℃/95-230℉, default temp is 60℃/140℉)
3. Work mode:
3.1 Normal working mode
Press "P" to start the sauna heater directly, its operation time can last 4
hours.
3.2 Preset working mode
A. Auto-start setting (Max 24hours):
Press "Prepare to place" to fix the time, then press "H" and "M" to set time
before "P" to finish.
B. Auto-Stop setting (Min 10mins, Max 4hours):
Press "Control time" to adjust the time, then press "H" and "M" to set time,
before time table finishing blink.
Remark: Step 1, 3.1 and 3.2.A must be operated during unworking of
sauna heater; Step 2 and 3.2.B must be operated during working of sauna
heater)
SAUNA ROCKS
Load sufficient sauna rocks(10-15kg) into the sauna heater after finishing
the installation of sauna heater and controller.
ATTENTION:
Sauna rocks must be of best quality because temperature inside sauna
- 9 -