Operation; Maintenance - JUNO JDA 5330 Montage- Und Gebrauchsanleitung

Fixing the hood
Apply the scheme supplied (Nº 49A) on the
right of the cabinet so that the lines marked
by the arrows match the cabinet ensuring
that they meet at the back and under.
Mahe 2 holes, following the sign on the
scheme(fig. 4).
Carry out the same operation on the left.
Fix the hood to the cabinet using screws E
(4,5x16) supplied with the appliance (fig. 4).
Use the shim F supplied with the hood for 16
mm cupboard side panels.
Fit the shim F to the left and to the right of the
fixing curves of the hood and hook them in
the holes.
Adjusting the removable drawer
The hood may be mounted in cabinets with
different depths.
The back of the drawer can be adjusted so
that the front of the removable drawer is the
same depth as the cabinet.
Proceed as follows: unscrew the screws G,
move the square plates H as required and
tighten the screw G (fig. 5).

Operation

The hood model JDA 5330 is fitted with two
motors.
The speed of the motors is adjusted by
means of a 4-SPEED switch.
Use the high speed switch only in case of
high concentration of vapour.
The hood should be switched ON several
minutes before you start cooking and should
be allowed to run until all the vapours have
been eliminated.
Speed switch
The switching plate is fitted with two switches
one for continuous adjustment of the
ventilator (left switch) and one for illuminating
the work surface (right switch).

Maintenance

Before performing any maintenance
operation, disconnect the hood from the
electricity.
Metal grease filter
Wash the filter, in a dishwasher or with
detergent and water, periodically according
to how often the appliance is used, but at
least once every30 days.
Attention! When washed in a dishwasher,
the metal grease filter may discolour.
Before refitting the filter ensure that it is
perfectly dry.
Removing the Grease Filters - Fig. 3
a. Remove the pull-out drawer completely.
b. Press the side handles (F) towards the
Putting the Filters Back in Place
a. Remove the pull-out drawer completely
b. Close the drawer and install the remaining
Active Carbon Filter
This filter eliminates the odours and vapours
which form during cooking.
When used in normal conditions it should be
replaced at intervals of 6-8 months.
These filter can be ordered from the supplier
The carbon filter cannot be washed or
regenerated.
To dismount the filter proceed as follows:
Press the two buttons C (fig. 3), pull the filter
slightly forwards and remove it.
Attention
Failure to observe the rules for cleaning the
appliance and changing and cleaning the
filters may cause fires.
Therefore, we recommend observing these
Light switch
instructions.
8
opposite side and remove the filters.
and mount the grease filter so that it
covers the drawer.
grease filter.