Apollo Tikki Gebrauchsinformationen Seite 15

STRUCTURE
Danger of pressure loss!
If the valve is not closed properly, the pressure in the board may decrease unintentionally or the valve
may be contaminated.
- Always keep the valve closed when not inflating or deflating the board.
- Make sure that the area around the valve is always clean and dry.
- Prevent sand or other impurities from entering the valve.
1. unroll the board and lay it down with the bottom side down on a smooth, even and dry surface.
2. place the hose on the screw connection of the pump and tighten it
3. open the valve flap on the board
4. make sure that the valve is closed. If the valve is open, press the valve pin down once to close it. As soon as you
release the valve pin, the valve remains fixed in the closed position.
5. Place the pump hose on the valve and tighten it.
6. inflate the board.
7. Check the air pressure on the pressure gauge while inflating.
8. Stop inflation when the air pressure reaches 0.7 bar (10 psi) to a maximum of 1.04 bar (15 psi).
9. remove the hose from the valve.
10. Place the valve cap back on the valve and tighten it.
Deflate
1. make sure that the area around the valve is dry and clean Remove water and dirt if necessary.
2. remove the valve cap.
3. Press the valve pin slightly into the valve.
4. air slowly escapes from the board.
5. Keep the valve pin pressed until the air pressure in the board has decreased sufficiently.
6. release the valve pin again. The valve will close automatically.
If you want to release the air from the board completely, press the valve pin completely into the valve.
Valve pin