Operation - ZANKER KBA22422SK Benutzerinformation

• Do not let hot items to touch the plastic parts of the
appliance.
• Do not store flammable gas and liquid in the
appliance.
• Do not put flammable products or items that are wet
with flammable products in, near or on the
appliance.
• Do not touch the compressor or the condenser.
They are hot.
Internal light
• The type of lamp used for this appliance is not
suitable for household room illumination
Care and cleaning
Warning! Risk of injury or damage to the
appliance.
• Before maintenance, deactivate the appliance and
disconnect the mains plug from the mains socket.
• This appliance contains hydrocarbons in the cooling
unit. Only a qualified person must do the
maintenance and the recharging of the unit.

Operation

Switching on
1. Insert the plug into the wall socket.
2. Turn the Temperature regulator clockwise to a
medium setting.
Switching off
To turn off the appliance, turn the temperature regulator
to the "O" position.
Temperature regulation
The temperature is regulated automatically.
A medium setting is generally the most
suitable.
However, the exact setting should be
chosen keeping in mind that the
temperature inside the appliance
depends on:
• room temperature,
• how often the door is opened,
• the quantity of food stored,
• the location of the appliance.
4
• Regularly examine the drain of the appliance and if
necessary, clean it. If the drain is blocked, defrosted
water collects in the bottom of the appliance.
Disposal
Warning! Risk of injury or suffocation.
• Disconnect the appliance from the mains supply.
• Cut off the mains cable and discard it.
• Remove the door to prevent children and pets to be
closed inside of the appliance.
• The refrigerant circuit and the insulation materials of
this appliance are ozone-friendly.
• The insulation foam contains flammable gas.
Contact your municipal authority for information on
how to discard the appliance correctly.
• Do not cause damage to the part of the cooling unit
that is near the heat exchanger.
1. Turn the Temperature regulator toward lower
settings to obtain the minimum coldness.
2. Turn the Temperature regulator toward higher
settings to obtain the maximum coldness.
Caution! If the ambient temperature is
high or the appliance is fully loaded, and
the appliance is set to the lowest
temperatures, it may run continuously
causing frost to form on the rear wall. In
this case the dial must be set to a higher
temperature to allow automatic
defrosting and therefore reduced energy
consumption.