Virutex FR192VG Gebrauchsanweisung Seite 11

Because an excessive depth can cause
overloading of the motor or difficulty in
controlling the machine, this depth in one
pass should not exceed 3 mm in grooving
work. If it is necessary to make deeper
grooves, make several passes of 3 mm until
you reach the desired depth.
7.1 ELECTRONIC SPEED ADJUSTMENT
Constant speed control.
Soft start.
8. ATTACHING THE SQUARE (Fig. 4)
Disconnect the machine from the mains
before performing this operation.
9. APPLICATIONS
Disconnect the machine from the mains
before performing this operation.
9.1 APPLICATION FOR RADIUS (Fig. 5)
In any job requiring the use of a guide
ring (see section 11. Accessories) (Fig.
15) it is not possible to use the nozzle
M (Fig. 17).
9.2 HINGE TEMPLATE APPLICATION (Fig. 6)
9.3 APPLICATION FOR COPYING
ON ANY TEMPLATE (Fig. 8)
10. MAINTENANCE OF BRUSHES
AND COLLECTOR (Figs. 9 and 10)
dition.
11. ACCESORIES
Template guide ring (Fig. 15)
-
Always use bits with the correct size of
shank for the chuck being used and adjust
the velocity of the tool.
-
-
-
-