Parts And Components; Before Use; Operation - Cecotec Titanglass 1000 Bedienungsanleitung

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1
1. On/off button
2. Main body
3. Power cord
4. Lid
5. Glass bowl
6. Blades

2. BEFORE USE

- After removing the packaging, make sure all parts and accessories are present and
undamaged. Do not use the appliance if it is visibly damaged. In that case, contact with the
official Technical Support Service of Cecotec.
- Clean all non-electrical parts with soap and warm water. You can wipe the main body of
the product with a clean cloth.
- Make sure that the mains voltage matches the voltage stated on the rating label of the
appliance.

3. OPERATION

1. Place the blades on the shaft at the bottom of the glass bowl.
Note
You can use the chopper with 2 or 4 blades on the blade. The use of two blades is sufficient
to grind most foods. For harder foods or even crushing ice, use the 4 blades. To change the
blades, pull the plastic piece attached to the shaft where the two extra blades meet.
Fig. 2
2. Put the ingredients you want to process into the bowl.
3. Close the bowl lid and place the main body on it. Rotate the main body until it clicks into
place. The engine will not operate unless the main body is correctly installed.
4. Plug the product into the mains and press the power button to process the food.
5. When finished, unplug the product and remove the processed food.
TITANGLASS 1000
30