Genmitsu Cubiko Anweisung Seite 3

Disclaimer
Please be careful when using your CNC machine. This machine is an electrical device with
moving parts and dangerous working areas.
● Genmitsu CNC Machines are for Indoor Use Only.
● You must be 18 years or older to operate this machine unless supervised by a knowledgeable
adult familiar with the machine.
● Wear proper Personal Protection Equipment (Safety Glasses, etc.).
● Always place the CNC Machine on a stable surface.
● The Cubiko utilizes a high amp power supply. It is recommended that you do not plug the
CNC Router into an extension cord or power strip, as it may damage the machine.
● Ensure the Emergency Stop Button is easily accessible at all times.
● Never disassemble the Power Supply or Electrical Components. This will VOID the warranty.
● DO NOT TOUCH the machine spindle or place any body part near the working area when
the machine is operating. Serious injury may occur.
● DO NOT leave children unsupervised with the CNC machine, even when it's not operating.
Injury may occur.
● DO NOT leave the machine unattended while it's operating.
● Ensure your CNC machine is in a well-ventilated area. Some materials may discharge
smoke or fumes during operation.