Instar IN-8015 Bedienungsanleitung Seite 23

01 - Photosensor
02 - Lens
03 - Infrared LEDs
04 - PIR Detector
05 - Loudspeaker
06 - MicroSD Card
07 - Microphone
08 - Power Connector
09 - WPS / Reset
10 - Alarm In/Out
11 - Antenna Connector
12 - Network Port
13 - Audio Output
14 - Status LED
15 - Mount
16 - Camera Label
4.3. Status LEDs
Status LED
Constant on
Slow Flashing
Fast Flashing
Go to http://install.instar.com
Twilight switch for IR LEDs
Wide-angle (focal length: 4.3mm / field of view:
10 IR LEDs (nightvision @ 850nm)
Integrated passive infrared motion detector
Integrated loudspeaker
Slot Slot for MicroSD/SDXC
For noise detection / audio rec. / two-way
5V / 2A DC - Plug Ø: 1.35mm (in) / 3.5mrn (out)
3 seconds for quick WiFi setup / 15-20 seconds for reset
Input for potential free external alarm sensors
Output (relay) can support max. 24V/1A
RP-SMA WiFi antenna connector
RJ45 LAN port / connector
3.5mm jack for earphone / active speaker
Red: power; blue: network status (both can be turned on/off)
Standard camera thread for included stand (1/4"-20
P2P IL), LAN MAC address and serial number
Blue LED
Connected to WiFi
Connecting
N/A
LED is turned
is not plugged into power
cards (max. 128GB - 16GB included)
for Cat5e LAN cable or higher
via WPS
off, or camera
900 dia.)
audio intercom
(not for POE version)
Red LED
N/A
Camera at work
Upgrading firmware
LED is turned off, or camera
is not plugged into power
6-EN
UNC)