Toro 66-7950 Einbauanleitung

TORO
Since this instruction sheet covers only a minimal amount of information necessary to maintain and operate
your machine, we suggest
ferred to for instructions
INSTALL LAMP ASSEMBLY
1. Make sure engine
moved from ignition switch.
2. Using U-bolt, washers
loosely secure lamp mount
fig. 1.
3. Route wires and fuse
through U—bolt.
4. Secure U-bracket to lamp mount with a carriage
bolt, lockwasher and nut. Do not overtighten
lamp adjustment will be affected.
5. Secure lamp assembly
with flange head screw,
flange locknut. Place a washer
tween the U-bracket and lamp
tighten.
6. Connect short jumper
bly.
7. At right side of engine,
gine wire.
8. Tighten all fasteners.
9. Make sure wire harness
operation of control levers or cables.
MODEL
that you keep this material
concerning safe operation
is stopped and key is re-
and nuts supplied in kit,
to handle as shown
holder inside channel
nut or
bracket to U-bracket
(2) lockwashers and
on each side
bracket. Do not over-
wire to lamp wire assem-
plug jumper wire into en-
does not interfere
@TheTOROCompany
NO. 66-7950
LIGHT
with your Operator's
and proper maintenance
in
and
a
be- 5
4
with
-1988
FORM NO. 3313-639
INSTALLATION
INSTRUCTIONS
KIT
Manual so that both may be re-
procedures.
3
1
2
Figure 1
Lamp mount
I.
2. U-Bracket
3. Lamp assembly
4.
Lamp wire assembly
S. Jumper wire