REX RX-600 G Bedienungsanleitung Seite 30

Assembly
STEP 4
GB-30
REX_Trainer_RX600G_13.indd GB-30 REX_Trainer_RX600G_13.indd GB-30
All manuals and user guides at all-guides.com
WARNING
1. Release the four screws (50) from the retainer of the
2. Mount the rear handgrips (8) to the retainer of the
3. Mount both pedals (44 L&R) to the crossbar (9 L&R)
4. Set up the machine at the designated location.
5. Use the rear left and right height regulation to align
6. Before every workout, pull the seat adjuster (33) up
seat clamp (10).
seat clamp (10) using the screws released in Step 1.
During the assembly, make certain that both hand-
grips are installed on the respectively correct side.
For better identifi cation, the handgrips have been
marked with an „L" for left and an „R" for right (see
Fig. 10).
of the device.
During the assembly, make sure that both pedals are
installed on the respectively correct side, otherwise
they could break out. The right pedal is screwed in
clockwise and the left pedal is screwed in anti-
clockwise. For better identifi cation, the pedals have
been marked with an „L" for left and an „R" for
right. Tighten both pedals fi rmly (see Fig. 11)
the device so that it stands securely and fi rmly.
and adjust the seat distance that best suits you (see
Fig. 12). The machine is ready to operate.
Assembly
21.05.13 10:46 21.05.13 10:46