Assembly - Rex Rx-600 G Bedienungsanleitung

Assembly

STEP 2
GB-28
REX_Trainer_RX600G_13.indd GB-28 REX_Trainer_RX600G_13.indd GB-28
All manuals and user guides at all-guides.com
WARNING
1. Release the four screws (55) and washers (77) from
2. Connect the pulse sensor cables (17+99) on both
3. Mount the front handgrips (101) to the handlebar
4. Release the four screws (94) at the back of the dis-
5. Connect the battery cable (112) to the cable from
6. Carefully insert the cable into the display until the
7. Connect the upper computer cable (15) and both
8. Carefully insert the cables into the handlebar sup-
9. Screw the display together with the screws released
10. Release both screws (76) from the seat adjuster
11. Push the seat adjuster (33) into the retainer of the
12. Screw the seat adjuster (33) together with the
the front handgrips (101).
sides.
support tube using the screws released in Step 1.
During the assembly, make certain that both hand-
grips are installed on the respectively correct side.
For better identifi cation, the handgrips have been
marked with an „L" for left and an „R" for right (see
Fig. 4).
play (14).
the battery opening of the display (14).
batteries have contact and close the opening with
the battery cover (113).
pulse sensor cables (99) to the cables on the back of
the display (14).
port tube (4) until they touch the display.
in Step 4 (see Fig. 5).
(33).
seat clamp (10).
screws released in Step 10 (see Fig. 6).
Assembly
21.05.13 10:46 21.05.13 10:46