Werbung
Verfügbare Sprachen
Verfügbare Sprachen
E. Repair
1. Have your power tool serviced by a qualified repair person using only identical
replacement parts. Pay attention to the power and voltage in case of the electrical
connection. It is dangerous for the operator and the power tool when the supply
voltage is higher than the voltage required by tool. Therefore, it is prohibited to
plug in before confirming voltage supply. Conversely, it will be harmful to the motor
when the supply voltage is lower than the required voltage of electric tools.
GENERAL SAFETY WARNINGS COMMON FOR POLISHING OPERATION
1. This power tool is intended to function as a polisher.
2. Operations such as grinding, sanding, wire brushing or cutting-off are not
recommended to be performed with this power tool. Operations for which the
power tool was not designed may create a hazard and cause personal injury.
3. Do not use accessories which are not specifically designed and recommended by the
tool manufacturer. Just because the accessory can be attached to your power tool,
it does not assure safe operation.
4. The accessories should be operated with the rated speed which must be at least
equal to the speed marked on the power tool.
5. The outside diameter and thickness of the accessory must be within the rated
capacity of the power tool. Incorrectly sized accessories cannot be adequately
guarded or controlled.
6. Threaded mounting of accessories must match the tool spindle thread.
7. Do not use a damaged accessory.
8. Hold the power tool by insulated gripping surfaces only, when performing an
operation where the cutting accessory may contact hidden wiring or its own cord.
9. Position the cord clear of the spinning accessory.
10.
Put down the power tool only after the rotation has come to a complete stop.
11.
Do not run the power tool while carrying it at your side.
12.
Regularly clean the power tool's air vents.
13.
Do not operate power tool near flammable materials.
14.
Do not use accessories that require liquid coolants.
15.
Be careful when working corners, sharp edges, etc.
EN
23
Werbung
