Tunturi 18TSFR1000 Montageanleitung Seite 14

English
⚠
WARNING
• Assemble the equipment in the given order.
• Carry and move the equipment with at least
two persons.
⚠
CAUTION
• Place the equipment on a firm, level surface.
• Place the equipment on a protective base to
prevent damage to the floor surface.
• Allow at least 100 cm of clearance around the
equipment.
• Refer to the illustrations for the correct
assembly of the equipment.
Additional environmental information
Packaging disposal
Government guidelines ask that we reduce the
amount of waste material disposed of in land fill
sites. We therefore ask that you dispose of all
packaging waste responsibly at public recycling
centres.
End of life disposal
We at Tunturi hope you enjoy many years of
enjoyable use from your fitness trainer. However,
a Time will come when your fitness trainer will
come to the end of its useful life. Under 'European
WEEE Legislation you are responsible for the
appropriate disposal of your fitness trainer to a
recognised public collection facility.
Use
Adjusting the support feet (Fig� E)
The equipment is equipped with adjustable
support feet.
If the equipment feels unstable, wobbly, or not
levelled well, these support feet can be adjusted
to make the required corrections.
- Turn the support feet in/ out as required to put
the equipment in a stable and as well possible
levelled position.
- Tighten the locknut's* to lock the support feet.
14
‼
NOTE
• The equipment is most stable when it is
as low to the floor as possible. Therefore,
start to level the equipment by turning all
support feet fully in, before turning out the
required support feet to stabilize and level
the equipment.
• The centre foot suppose to be a few
millimetres from the floor when not seated on
the rower seat.
Folding (Fig� G)
- Loosen the fixation knob.
- Fold the aluminium rail.
- Securing aluminium rail with the lock pin.
Unfolding
same as in folding, but in reverse following order.
Power supply (Fig� E-1)
The trainer is powered by an external power
supply. Refer to the illustration to locate the
‼
trainer power input.
NOTE
• Connect the power supply with the trainer
before connecting it to the wall outlet.
• Always remove power cord when
• Machine is not in use.
How to row
Catch
Comfortably forward
with straight back and
arms.
Drive
Push with the legs
while arms remain
straight.