Werbung
Verfügbare Sprachen
Verfügbare Sprachen
FILLING THE TANK
- Turn the top cap counterclockwise to close
- Remove the top cap and fill the tank via
- Turn the top cap clockwise to seal the tank
- For transport, close the liquid control by
NOTE:
The spare parts kit includes both 15*1 and 16*1 O-rings. With the 15*1 O-rings,
the liquid control is very smooth; with the 16*1 O-rings, it is tighter.
If 2x 15*1 O-rings are too smooth and 2x 16*1 O-rings are too tight, you can
also install one 15*1 (top) and one 16*1 O-ring (bottom) on the base.
22 English
the liquid control and open the top cap.
the two slots above the reservoir.
and reopen the liquid control. The atomizer
is now ready for use.
turning the base counterclockwise.
Open it again by turning it clockwise after
transport.
CHANGING SIDE
AIRFLOW INSERTS
- Remove the tank.
- Detach the AFC cover.
- Push the airflow screws out of the
chamber and insert new airflow
pins from the outside.
- Reattach the AFC cover and
turn it until it locks into place.
The cover is correctly mounted when
the ring and base are aligned.
CHANGING THE BOTTOM
AIRFLOW SCREW
- Unscrew the RTA from the mod
and replace the 510 positive pin.
English
23
Werbung
