General Maintenance - Vevor Sr-R005A Bedienungsanleitung

■Shrink tubing for electrical work
■Shrink plastic film for wrapping or weatherproofing
WARNING
！
Do not place secondhand on top of tool or near nozzlo at any time.Holding the
tool on or near the nozzlo can cause serious personal injury
■Move the heat gun until the nozzle is close to the area being heated.
NOTE:Experiment with scrap materials to determine the proper amount of
heat,distance and time for your project.
WARNING
！
During heating,move the tool back-and-forth.Avoid lingering or pausing in one spot
as this could overheat or potentially ignite the material being heated.
■ Allow the heat gun and heating surface to cool completely before storing the tool.
WARNING
！
When servicing.use only identical replacement parts.Useof any other parts
could create a hazard or cause.product damage
！ WARNING
Before inspecting.cleaning.or servicing the unit,stop the heat gun,wait for the
heat gun to cool,and remove the battery pack(not include).Failure to follow
these instructions canresult in serious personal injury or property damage.

General Maintenance

Avoid using solvents when cleaning plastic parts.Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their
use.Use clean cloths to remove dirt,dust,oil,grease,etc.
Cleaning The Heat Gun
The heat gun should be kept clean,dry,and free of oil or grease.Only a mild soap
and damp cloth should be used to clean the heat gun.Do not allow liquid to enter
the tool.
The high temperatures of the heat gun will cause the nozle to turn dark over
time.This is normal and will not affect its performance or life.
Maintenance
- 13 -