VEVOR SR-R005A Bedienungsanleitung Seite 11

■Place drop cloths in the work area to catch any paint chips or
peelings,Wear protective clothing such as extra work shirts,overalls and
hats.
■Work in one room at a time.Furniture should be removed or placed in the
centre of the
room and covered.The work area should be sealed off from the rest of the
home by sealing the doorway with a rag.
■Children,pregnant or potentially pregnant women and nursing mothers should
not be present in the work area until the work is done and all clean up is
complete.
■Wear a dust respirator mask or a dual fter (dust and fume)respirator mask
which has been aprvedbytho Occupational Satety and Halth Administration
(OSHA,the National Institute of
Safety and Health (NIOSH),Or the United States Bureau of Mines.These
masks and replace able flters are readily available at major hardware
stores.Be sure the mask fits.Beards and facial hair may keep masks from
sealing properly.Change fiters often.DISPOSABLE PAPER MASKS ARE NOT
ADEQUATE.
■Use caution when operating the heat gun.Keep the heat gun moving,as
excessive heat will generate fumes,which can be inhaled by the operator.
■Keep food and drink out of the work area.Wash hands,arms and face
and rinse mouth before eating or drinking.Do not smoke or chew gum or
tobacco in the work area.
■Clean up all removed paint and dust by wet mopping the floors.Use a wet
cloth to clean all walls,and other surfaces where paint or dust is clinging.DO
NOT SWEEP,DRY DUST
OR VACUUM.Use a high phosphate detergent or trisodium phosphate
(TSP)to wash and mop areas
■At the end of each work session put the paint chips and debris in a double
plastic bag.close it with tape or twist ties and dispose of properly
■Remove protective clothing and work shoes in the work area to avoid carrying
dust into the rest of the dwelling.Wash work clothes separately.Wipe shoes off
with a wet rag that is then washed with the work clothes.Wash hair and body
thoroughly with soap and water.
- 10 -