Prostor FRAME P6 Bedienungsanleitung Seite 7

STEP 2 Mounting the Pole
WARNING: First install optional sockets on the
pole if the parasol requires heating or power
outlets!
Ensure correct alignment of the pole. The top
of the pole has two holes on each side.
Attach all mounting components per side to
the pole. These are packaged with the parasol
frame. Attach the short mounting rods to the
suspension block with the top two bolts
loosely. Attach the long rod in the middle of
the block.
Mount the suspension block to the top of the
pole by sliding the rods into the pole and
securing them with the provided bolts. Only
tighten all bolts firmly at this stage.
Then, fasten the bracket for the gas spring to
the mounting rod in the pole.
Slide the gliding carriage along with the wheel
into the bottom of the pole, ensuring the
black knob is at the bottom, and tighten it to
prevent movement.
Finally, place the pole onto the pole support
and secure it using the provided Allen bolts at
the bottom and in the pole slots. If applicable,
connect the 230V power supply through the
pole to the top. Place the protective cap on
the pole.
STEP 3 Mounting the Frame
Take the parasol frame and attach it to the
suspension block at the top of the pole using
an axle with nuts.
Lift and rotate the closed frame upward, then
mount the gas spring to the previously
installed bracket on the pole using an axle and
locking ring.
Lower the frame and secure it at the bottom
to the gliding carriage using an axle with nuts.
STEP 4 Mounting the Canopy
Open the parasol frame halfway.
Unscrew the protective cap at the top of the
frame.
Place the canopy over the frame and screw
the protective cap back on.
Push in the ends of the ribs and pull the
canopy pockets over these sections.
Connect the open canopy with the strap and
place it over the twist lock.